A circulation pump moves water within a marine aquarium. It helps distribute heat and suspended food and can keep debris moving toward filtration. It does not itself remove waste or guarantee that every part of the aquarium receives suitable flow.

Choose flow pattern before maximum output
Consider the tank’s length, rockwork and animals. A narrow jet and a broad stream with the same advertised gallons per hour can affect a coral very differently. Adjustable output and direction are useful when placing a pump around an existing reef.
Turnover is a rough comparison: a nominal 600-gallon-per-hour pump in 30 gallons represents 20 times the volume per hour. It does not mean each part of the tank receives that circulation. Do not treat a single turnover target as a prescription for every soft, LPS or SPS coral.
Three pump families to compare
Hydor Koralia
The Koralia Evo uses a magnet-suction mount and an adjustable joint for directing flow. Hydor lists several outputs and specifies compatibility with interval control. Confirm the exact model, voltage and permitted controller arrangement; do not assume any pump can tolerate rapid on/off switching.
Check the permitted glass thickness and space for both sides of the mount. Follow the instructions for handling the magnets and positioning the cable.
Tunze Turbelle nanostream
The nanostream 6045 has a stated flow range of 1,500–4,500 litres per hour and a magnetic mount rated for glass up to 15 mm thick. Nanostream is a product family, not one universally controllable pump. Verify how the chosen model adjusts flow and whether it supports your intended controller.
Maxspect Gyre-style pumps
Gyre-style pumps are designed to move a broad sheet of water rather than a concentrated propeller stream. Maxspect’s Jump Gyre range includes adjustable modes and flow directors. Compare the specific pump and controller generation, package contents and replacement rotors before buying.
The elongated pump body needs cleaning access. A broad flow pattern can still disturb sand or overwhelm corals if placed or adjusted poorly.
Position pumps by what happens in the tank
Start conservatively and watch the aquarium through the full operating program. Look for persistent debris accumulation, sand blowing away, coral tissue being forced against skeleton and fish struggling to rest or feed.
Redirect or reduce flow before adding more pumps automatically. Multiple streams can improve distribution, but opposing pumps do not guarantee an effective wave pattern. Leave access to clean the cages and impellers.
Match circulation to individual corals. Our LPS guide and SPS guide explain why those trade categories still contain different requirements.
Protect animals and maintain performance
Use suitable intake protection around vulnerable animals, especially mobile anemones. Inspect guards frequently because buildup can reduce flow. A feeding mode should resume normal circulation reliably.
Disconnect and clean the pump according to its manual, inspect the cord and mount, then check performance after reassembly. Keep controllers dry. If backup circulation is important, verify the exact battery or power-backup compatibility and test it; a mains-powered pump provides no circulation during an outage without backup power.




Hi there! Thanks for sharing a great article!
Could you tell me aquarium circulation pump vs. powerhead: What is the difference? Thanks in advance!